Glassine Food Sleeves

Better to let them cool first. Warm product makes glassine cling and it tears when the customer pulls it off. It is grease-resistant, but it is a thin paper with little wet strength.

On offset and flexo we hold the ink formulation, which gives a tight match run to run. Digital has a wider tolerance. If exact consistency across repeat runs matters more than short-run economics, we will quote the litho route.

We specify food-contact compliant boards and inks where the pack touches food directly. Tell us whether contact is direct or through a liner for glassine food sleeves, because it changes which stocks are available to you.

A grease-resistant coating or a greaseproof liner. Untreated board will always strike through eventually with hot, oily food — that is a property of the material rather than a quality fault, and it is inexpensive to design out.

Send the current specification or a physical sample and we will quote to match it rather than proposing an alternative you would then have to re-approve internally. Tell us the coating on the pack you are matching too. Grease and moisture resistance are not visible in a sample and they change which stocks we can quote.

All 50 US states, the United Kingdom, Canada and Australia, on the same timeline everywhere: 3 to 5 business days of production after artwork approval, then 5 to 7 business days in transit. Every run is made to order and shipped directly to your address rather than pulled from stock, so you receive current production rather than whatever has been sitting in a warehouse. Freight is costed separately by weight, volume and destination. If stock is going into a kitchen or a service counter rather than a warehouse, tell us — case sizes that a single person can lift and store matter more there than pallet efficiency.

Every run is cut to your dimensions — there are no stock sizes here. Send the product measurements rather than a box size and we will build the sleeve around them, then send a dieline template you can design onto.

We issue a dieline template sized to your product, prepress checks your artwork against it, and a proof comes back for sign-off. Nothing runs until you approve that proof, and sleeves then take 3 to 5 business days.

Yes. Once a first run is approved we hold the board, structure, dimensions, print method and finishes against your account, so a reorder references the same specification exactly rather than being re-derived. That includes the ink formulation, which is what keeps a brand colour consistent between runs rather than drifting a shade each time.

Recycled grades are available across most of the substrates we run for sleeves. Recycled content, kerbside recyclability and certified compostability are three different claims though, so tell us which one you intend to print.

A print-ready PDF or a vector file, with fonts outlined and any raster images at 300 dpi at final size. We supply the dieline to design onto, and prepress checks bleed, safe area and crease clearance before issuing a proof. The dieline we supply carries the crease positions, so keeping type clear of a crease is easier to solve at layout than at proof.

A flat 100 units on any format. Most sleeves in this range are quoted from 100 units upward because unit cost falls sharply above that, but the minimum exists so you can validate a structure first.