French Fry Sleeves

On offset and flexo we hold the ink formulation, which gives a tight match run to run. Digital has a wider tolerance. If exact consistency across repeat runs matters more than short-run economics, we will quote the litho route.

We specify food-contact compliant boards and inks where the pack touches food directly. Tell us whether contact is direct or through a liner for french fry sleeves, because it changes which stocks are available to you.

A grease-resistant coating or a greaseproof liner. Untreated board will always strike through eventually with hot, oily food — that is a property of the material rather than a quality fault, and it is inexpensive to design out.

A flat 100 units on any format. Most sleeves in this range are quoted from 100 units upward because unit cost falls sharply above that, but the minimum exists so you can validate a structure first.

3 to 5 business days after artwork approval, plus freight. Sleeve runs with applied finishes can take longer because each finish is a separate pass, and we confirm a firm date in writing with the quote.

Prices start from $0.30 per piece for large-volume orders. For this format the biggest levers are quantity, print route, board grade and how many finishing passes are involved. We quote each element separately so you can see where the money is going. Finishing passes are the lever buyers most often underestimate: each one is a separate run through the line.

Yes. We can send a plain unprinted sample so you can check the fit and structure, or a printed prototype for colour and finish. Sample costs are normally credited against the production order. Worth running a few through your actual line rather than checking them by hand: fill speed and hot contents find fit problems that a desk check does not.

Send the current specification or a physical sample and we will quote to match it rather than proposing an alternative you would then have to re-approve internally. Tell us the coating on the pack you are matching too. Grease and moisture resistance are not visible in a sample and they change which stocks we can quote.

All 50 US states, the United Kingdom, Canada and Australia, on the same timeline everywhere: 3 to 5 business days of production after artwork approval, then 5 to 7 business days in transit. Every run is made to order and shipped directly to your address rather than pulled from stock, so you receive current production rather than whatever has been sitting in a warehouse. Freight is costed separately by weight, volume and destination. If stock is going into a kitchen or a service counter rather than a warehouse, tell us — case sizes that a single person can lift and store matter more there than pallet efficiency.

Every run is cut to your dimensions — there are no stock sizes here. Send the product measurements rather than a box size and we will build the sleeve around them, then send a dieline template you can design onto.

We issue a dieline template sized to your product, prepress checks your artwork against it, and a proof comes back for sign-off. Nothing runs until you approve that proof, and sleeves then take 3 to 5 business days.

Yes. Once a first run is approved we hold the board, structure, dimensions, print method and finishes against your account, so a reorder references the same specification exactly rather than being re-derived. That includes the ink formulation, which is what keeps a brand colour consistent between runs rather than drifting a shade each time.