Personalized Candle Labels

At the widest point, which is frequently not the base, and including the cap or pump. Send us the actual container if you can — a measurement from a drawing misses flex and applied label thickness, and both decide whether personalized candle labels close cleanly.

More than most brands allow for. Ingredient copy and any warnings compete directly with the design, and adding them late usually forces a reflow. We block the area on the dieline before you commit design time.

On offset and flexo we hold the ink formulation, which gives a tight match run to run. Digital has a wider tolerance. If exact consistency across repeat runs matters more than short-run economics, we will quote the litho route.

It matters more than most buyers expect. Adhesive keys differently to glass, coated card, matte plastic and cold or damp surfaces. Tell us the substrate and the application temperature and we will match the adhesive.

A print-ready PDF or a vector file, with fonts outlined and any raster images at 300 dpi at final size. We supply the dieline to design onto, and prepress checks bleed, safe area and crease clearance before issuing a proof. On a die-cut face, keep live copy clear of the cut edge — a small amount of movement on the die is normal and copy set to the edge will lose it on some of the run.

A flat 100 units on any format. Most labels in this range are quoted from 100 units upward because unit cost falls sharply above that, but the minimum exists so you can validate a structure first.

3 to 5 business days after artwork approval, plus freight. Label runs with applied finishes can take longer because each finish is a separate pass, and we confirm a firm date in writing with the quote.

Prices start from $0.30 per piece for large-volume orders. For this format the biggest levers are quantity, print route, board grade and how many finishing passes are involved. We quote each element separately so you can see where the money is going. Finishing passes are the lever buyers most often underestimate: each one is a separate run through the line.

Yes. We can send a plain unprinted sample so you can check the fit and structure, or a printed prototype for colour and finish. Sample costs are normally credited against the production order. Ask for the printed prototype rather than the plain sample if the question is finish — soft-touch, foil and deboss all read differently in the hand than on a screen.

Send the current specification or a physical sample and we will quote to match it rather than proposing an alternative you would then have to re-approve internally. A physical sample tells us more than a specification sheet — board caliper and coating are usually described loosely and measured exactly.

All 50 US states, the United Kingdom, Canada and Australia, on the same timeline everywhere: 3 to 5 business days of production after artwork approval, then 5 to 7 business days in transit. Every run is made to order and shipped directly to your address rather than pulled from stock, so you receive current production rather than whatever has been sitting in a warehouse. Freight is costed separately by weight, volume and destination. Roll-form work travels well and takes very little space, so freight is rarely the deciding cost on this format even at high quantities.

Every run is cut to your dimensions — there are no stock sizes here. Send the product measurements rather than a box size and we will build the label around them, then send a dieline template you can design onto.